Laura Schaefer and Arvind Atreya, Department of Mechanical Engineering, Rice University, Main St., Houston, TX, USA
International Journal of Advanced Information and Communication Technology
Received On : 10 July 2021
Revised On : 01 August 2021
Accepted On : 20 September 2021
Published On : 05 November 2021
Volume 08, Issue 11
Pages : 226-230
Abstract
Life of any gear is increased by providing chamfering on the gear tooth. Most of the gears used in practical application today are not chamfered. This due to the high cost involved in the chamfering process. To reduce the chamfering cost, we have designed a novel simple machine and fabricated. In this work, modelling, design calculation of the chamfering machine and the working of the machine is explained. Introducing chamfering in gear tooth helps to avoid the noise, breakage of gear tooth and to increase the gear tooth. The fabricated machine was tested and found working satisfactorily.
Keywords
Gear; Chamfering; Gear life; Breaking system.
Cite this article
Laura Schaefer and Arvind Atreya, “Analysis of Design and Fabrication of Gear Tooth Chamfering Machine, ” INTERNATIONAL JOURNAL OF ADVANCED INFORMATION AND COMMUNICATION TECHNOLOGY, pp. 226-230, November. 2021.
Copyright
© 2021 Laura Schaefer and Arvind Atreya. This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.